Buick Skylark Crankshaft Position Sensor

Buick Skylark Crankshaft Position Sensor

Postby usedcar129 » Fri Jul 10, 2009 10:11 am

So my uncle has a problem He has 1993 Buick Skylark v6 3.3l and i am not getting any spark. so he changed out the ignition control module and the coil packs and am still getting no spark. could the CPS cause this and if so how do he go about replacing the sensor and how much the senor costs.. thanks

used buicks
Posts: 23
Joined: Fri Jul 03, 2009 5:59 am

Re: Buick Skylark Crankshaft Position Sensor

Postby jeffhall009 » Sun Dec 27, 2009 6:57 am

Hey you can see the videos on you tube for this problem and get it solved. Just search for that.

Automotive LED Tail Lights
Posts: 10
Joined: Sat Dec 26, 2009 5:15 pm

Re: Buick Skylark Crankshaft Position Sensor

Postby insane.nick » Tue Nov 29, 2011 5:57 am

the crank sensor is down by the crank pulley. get a harmonic puller because you will need it. take the crank pulley off, pull the harmonic balancer off, unplug the sensor. the way i do it is a mark the old 1 before i take it off so i can put the new 1 on the same way. there are 2 bolts that holds it, they need to come out and the sensor will come off. just align the sensor with the mark you made and install the sensor. snug the bolts up, plug the sensor in, put the harmonic balancer back on and make sure it aligns with the fins on the harmonic, put the bolt back in and tighten it, put the pulley back on and the belt.
Posts: 315
Joined: Sat Nov 19, 2011 7:30 am

Return to Buick Forum

Who is online

Users browsing this forum: No registered users and 1 guest